Heat Pump Repair And Efficiency Tips

furnace repair

During the cold months of the year, you need to heat your home. One of the best units you should go for is a heat pump. Is this the first time you are using a heat pump? There are plenty of tips you need to know to properly use it. To help you out, here are tips on how to properly use the heat pump as given by heat pump repair professionals:

Don’t bother too much with a temperature reading

When you are using a furnace or any other heating appliance, you have to think about the temperature at which it is operating at. This means that you have to keep on reading the settings so that you can adjust them appropriately.

When you are using a heat pump, you don’t need to worry too much about this. This is because the temperature you have set might not function as well as its supposed to. The best way of going about it is setting the heat pump to a comfortable temperature then adjust it accordingly over a few days, to a temperature that you are comfortable with.

Lower your old heating system

Had you installed a furnace or any other appliance in your home prior to installing a heat pump? You should lower its thermostat settings. Experts recommend that you set the thermostat 10 degrees Fahrenheit lower than what you are used to.

When you do this, you reduce the competition between the old heating system and the heat pump. As a consequence, you end up saving a lot of money and energy. When you lower the thermostat settings, you allow the old heating system to work as a backup heat source so that you have a source of heat in the event the heat pump fails.

Let the heat pump work

Many people tend to keep on interfering with the settings of their heating appliances. When they are leaving the house for work, they tend to lower the settings. While they end up saving a lot of energy over the long run, you don’t have to do the same thing with your heat pump.

The heat pump reaches peak efficiency by maintaining a set temperature. This means that there is the way you are going to have an efficiently functioning heat pump when you keep on altering with the settings.

What is the best way out? You should find the setting that you are comfortable with then leave the heat pump to function at that temperature. In addition to eliminating the stress of keeping your eyes on the settings all the time, letting the unit work on its own saves you a lot of money and time in the long run.

Use it as much as you can

To save energy and avoid overworking the heat pump, many people go easy on their appliance. Don’t do this. Experts recommend that you use the heat pump as much as possible for you to get the most from it. For you to know your unit’s capabilities, you should open a few doors in order to expand the heating zone.

Stay away from the auto mode

You might have the impression that by setting your unit to function on “Auto” you will be saving yourself time and money but this isn’t the case. Heat pump professionals report that when you leave the unit on auto mode, you risk your appliance toggling unnecessarily between heating and cooling.

The best way of going about it is to set the unit to heat in winter and cool in summer. When you are using the heat pump, you will come across the “auto fan” feature. This is a completely different setting and there is no problem in using it.

Watch the fan speed

Just as you should use it as much as you can in order to get the most from it, you should use the right fan speed for you to increase the heat pump’s efficiency. The best way out is to always use high fan speeds that you are comfortable with.

When using the speeds, heating service repair Long Island professionals report that the unit tends to produce more ambient noise and air movement; therefore, you should be ready for it.  When using the fan speed, don’t forget to dial your preferred temperature setting.

This entry was posted in HVAC Repairs and Installation and tagged , , , , . Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *